Setup Page For PHYS141 Moments Of Inertia Lab
- IoLab device for each station.
- Check that dongle is properly paired with device.
- Check that batteries are at least 2.8V in software.
- No accessories needed in the box.
- One pair of hoops that fit over body of IoLab device. Hoops are cut from a cylindrical shipping tube and just happen to be about the correct size. I cut them approximately 3/4“ wide and use a fine file to dress up the outer and inner edges.
- One board to use as an incline plane.
Boards and hoops are stored in cabinet space under NE corner of island bench in KPTC216.
Carry over
Same pile of parts in the corner which has been used for the first two labs this quarter.
- Rods
- Clamps, including table edge clamps
- Galvanized steel tubing in ~4' lengths
- Rulers & meter sticks
- Protractors
- Calipers
- Masses of different types
- Mass scales
- String
- Scissors
- Taps
- C-clamps
- Ring stands