;#;
Setup Page For PHYS141 Moments Of Inertia Lab
;#;

{{ :phylabs:lab_courses:phys-141-wiki-home:fall-experiments:mom-inertia-apparatus.jpg?700 |}}

  * IoLab device for each station.
    * Check that dongle is properly paired with device.
    * Check that batteries are at least 2.8V in software.
    * No accessories needed in the box.
  * One pair of hoops that fit over body of IoLab device.  Hoops are cut from a cylindrical shipping tube and just happen to be about the correct size.  I cut them approximately 3/4" wide and use a fine file to dress up the outer and inner edges.
  * One board to use as an incline plane.

Boards and hoops are stored in cabinet space under NE corner of island bench in KPTC216.

{{ :phylabs:lab_courses:phys-140-wiki-home:fall-experiments:inertia-lab:phys141-board-hoop-storage.jpg?700 |}}

==== Carry over ====

Same pile of parts in the corner which has been used for the first two labs this quarter.

  * Rods
  * Clamps, including table edge clamps
  * Galvanized steel tubing in ~4' lengths
  * Rulers & meter sticks
  * Protractors
  * Calipers
  * Masses of different types
  * Mass scales
  * String
  * Scissors
  * Taps
  * C-clamps
  * Ring stands