Setup Page For PHYS141 Conservation Laws Lab

The setup is so basic there is no need for a photograph of it.

==== Carry over ====

Same pile of parts in the corner which has been used for the first two labs this quarter.

  * Rods
  * Clamps, including table edge clamps
  * Galvanized steel tubing in ~4' lengths
  * Rulers & meter sticks
  * Protractors
  * Calipers
  * Masses of different types
  * Mass scales
  * String
  * Scissors
  * Taps
  * C-clamps
  * Ring stands

==== Additions ====

In addition to the general collection of components the following need to be setout for each sation.

  * 1 IoLab device.
    * Connect each IoLab to the computer and ensure it is paired correctly with its associated dongle.
    * Check batteries, should be above 2.8V when shown in software.
    * The IoLab box should include an eye bolt, screwdriver, rigid bumper and the spring attached to a screw.  Do NOT include the 2" long stretchy spring, students cannot resist playing with them and stretching them out past the point of failure.
  * A board to be used as an incline.  There are 24" x 9" boards stored under the NE corner of the island bench.

{{phylabs:lab_courses:phys-140-wiki-home:fall-experiments:conservation-laws-lab:incline-bards.jpg}}